The vertical injection molding machine is controlled by microcomputer, and the power system is controlled by hydraulic transmission. The plastic is heated by the heating ring in the material tube, the screw of the mate
Rubber vertical injection molding machine 1. In principle, the total pressure of plastic injection into the mold should be based on no burrs. 2. Has the same contact effect to get the material into the mold. The right
Injection molding machine manufacturers First, the composition of the injection molding machine Injection molding machine is usually composed of injection system, mold clamping system, hydraulic transmission system, el
Injection molding machine structure Body frame (clamping mechanism, shooting table device,) Electrical Communication (Control Panel) Hydraulic system (oil flow channel) Cooling system (plastic injection device coolin
If the injection molding machine cannot open the mold, we first increase the mold opening force of the injection molding machine, and the mold opening force cannot be opened. open. For example, if you put it on a 500-g